Bikebuiler
Registered user
Greetings from Finland!
I'd like to use 1200GS exhaust flap and control servo in my (non BMW) project bike.
The challenge is, I don't know what is needed to drive the control servo. Could anyone help me here?
I know that out of four connector pins the middle ones are for power and ground.
But what kind of signal is there in outer pins used to control the flap position. Is it analog or digital?
I hope someone who has more knowledge or has an oscilloscope / logic analyzer and has been studying this topic could help me further.
Kindest regards,
Bikebuilder
I'd like to use 1200GS exhaust flap and control servo in my (non BMW) project bike.
The challenge is, I don't know what is needed to drive the control servo. Could anyone help me here?
I know that out of four connector pins the middle ones are for power and ground.
But what kind of signal is there in outer pins used to control the flap position. Is it analog or digital?
I hope someone who has more knowledge or has an oscilloscope / logic analyzer and has been studying this topic could help me further.
Kindest regards,
Bikebuilder