The Quill exhaust on my CCM is a lovely compact can, but it is too loud for practical usage.
Taking baffle is a short length of straight through 29mm ID pipe, so it is not really doing much.
I have fabricated an additional tube form perforated stainless and a stainless core plug, there are 130 3mm holes on the tube, whic provide more area than the existing piupe, so I am hoping to have mimnimsed any icrease in back-pressure, whilst disrupting the pulses o reduce the volume a bit.
Now I need to join it all together. I am about to go traipsing around some local welding shops, but had though about using the likes of the GoSystem QP8066H torch with MAPP gas and general brazing rods.
Has anyone used this before, or something similar, and know if it woudl be up to the job?
Taking baffle is a short length of straight through 29mm ID pipe, so it is not really doing much.
I have fabricated an additional tube form perforated stainless and a stainless core plug, there are 130 3mm holes on the tube, whic provide more area than the existing piupe, so I am hoping to have mimnimsed any icrease in back-pressure, whilst disrupting the pulses o reduce the volume a bit.
Now I need to join it all together. I am about to go traipsing around some local welding shops, but had though about using the likes of the GoSystem QP8066H torch with MAPP gas and general brazing rods.
Has anyone used this before, or something similar, and know if it woudl be up to the job?