Fitted a set of GS hand guards to the R Classic some time ago. Kettle 738 just asked for info on how I fitted them so here we are.
Looked at a few pictures of installations and not to happy with the end fitting so had my grandson make up some end bosses. Added a couple of torx bolts from EBay now looks like standard. Pictures show new and old large hole(GS) boss + bolt and couple of rubber washers to stop them twisting and fill the larger hole in the GS hand guards. Done at leased 6k miles so far without a problem. The bar clamps fitted without a problem just needed a bit of care and time to get just right position, one is a bit close to the master cyl but no problems.
Looked at a few pictures of installations and not to happy with the end fitting so had my grandson make up some end bosses. Added a couple of torx bolts from EBay now looks like standard. Pictures show new and old large hole(GS) boss + bolt and couple of rubber washers to stop them twisting and fill the larger hole in the GS hand guards. Done at leased 6k miles so far without a problem. The bar clamps fitted without a problem just needed a bit of care and time to get just right position, one is a bit close to the master cyl but no problems.