so would it be unusual to find no shims in the final drive? could my hub have been made perfect at the factory or is it just that somebody has been here and not re fitted them the bike has covered 43k
yes no shim to be found,,,,,
i have replaced the swing arm bearings and also the FD crown wheel bearings re measured and looks like a .5 shim would go in nicely and give required pre load,
still does not explain why there was no shim in there, as you said never seen one without and no one else has either, mystery
I have rebuilt loads. Never bothered putting the shims back in, just bodge it up quick like, get it sold and out the door . Last one I mashed togther was bought by a geezer called Ross, from Lincolnshire I think.....
I have rebuilt loads. Never bothered putting the shims back in, just bodge it up quick like, get it sold and out the door . Last one I mashed togther was bought by a geezer called Ross, from Lincolnshire I think.....