Bendy toy
Registered user
Sadly my ZFE doesn't seem to 'see' the unit I bought from Henk.
I'll just have to live with warnings flashing.
Ill put the unit on eBay at a knock down price, then hopefully sometime soon Bendy will come up with the ultimate solution.
Sent from my SM-J510FN using Tapatalk
I can't post a picture as I'm not on a hosting service and deleted Tapatalk ( too distracting). However its simple stuff with (almost the same circuit as shown in the AdvRider image. Total cost including Vero board (striped printed circuit board) and minimum order levels for resistors was just over £5. A bit more if you need solder and wires.
I soldered the 39K and 1 Meg resistors and potentiometer to the Veroboard giving a circuit as described by AdvRider except the 2K resistor is replaced by the the 5K potentiometer.
A full tank is all very well but a used fuel pump will struggle to fully empty the GSA tank when FPC is running in normal mode. When trip has covered about 75% of the range, you can turn up the pot. This will spoof a low fuel level and cause the pump to run at full power and fully empty the tank.
That's my hope. It's dark now so testing stopped.