Metal mule panniers
- Thread starter Tfemark
- Start date
They do, but you may have to trim one of the clamps (vertical) on the panniers.
This is due to one of the support braces on the frame interfering with the long clamp position.
It doesn't weaken the pannier or load-carrying capabilty.
The V-bracket welded to the frame below - shows the Metalmule arrangement. The MM pannier guide/clamp fits between the welds. On Touratech frame, the V is closer together, so the pannier guide/clamp needs to be trimmed by an inch.
Al
This is due to one of the support braces on the frame interfering with the long clamp position.
It doesn't weaken the pannier or load-carrying capabilty.
The V-bracket welded to the frame below - shows the Metalmule arrangement. The MM pannier guide/clamp fits between the welds. On Touratech frame, the V is closer together, so the pannier guide/clamp needs to be trimmed by an inch.
Al
ian6760
Registered user
I've just had my 1150 MM frames out to measure them as I'm making frames for my little Honda.
18mm tubing and inner measurements of 314mm x 212mm.
I have a set of MM frames and the exhaust to "balance" them, please PM me if you are interested. They were removed from my bike yesterday.
Mike
Mike
Similar threads
