Think someone has twiddled my bits... could not work out why one pot started higher on vac but was overtaken by the other as it went off tickover... but guessing someone has twiddles the min setting / tickover screw.
The one on the other side has blue paint on it and it’s been moved from factory set... any ideas on how to re-set them for base idle????
Its the one right at the back in the middle of this pic...
I’m guessing you take all cable tension out and set with vac gauges somehow.. but do I disconnect the anything?.. .. carbs are so much easier LOL...
The one on the other side has blue paint on it and it’s been moved from factory set... any ideas on how to re-set them for base idle????
Its the one right at the back in the middle of this pic...
I’m guessing you take all cable tension out and set with vac gauges somehow.. but do I disconnect the anything?.. .. carbs are so much easier LOL...