Beer mat drawings

Since you are asking... It's probably way out of my budget but any idea of an approximate cost and how much fuel it is going to hold.
 
Since you are asking... It's probably way out of my budget but any idea of an approximate cost and how much fuel it is going to hold.

At this point in time it’s looking like @£900 each,though this could be reduced if more were to be produced.
It would offer more flexibility in respect of replacing forks but it’s worth noting that certain mods would be needed to the mounting of electrics /brackets under the tank
And the actual tank mounts are different
 
Thanks for the response. Way out of my budget but it looks sweet.
 
Called in today

To see Paul, his work is amazing. All done by hand. You can just see the weld on the inside of the tank.
 

Attachments

  • 0C95F218-5A96-42AD-B7F8-F2FC4525658F.jpg
    0C95F218-5A96-42AD-B7F8-F2FC4525658F.jpg
    241.5 KB · Views: 668
  • 91C9BAF2-C74E-45FB-8536-DC6D4FF2FC64.jpg
    91C9BAF2-C74E-45FB-8536-DC6D4FF2FC64.jpg
    231.7 KB · Views: 680
That Colin is some serious workmanship, good on you Sir.
 
Quick question about the red one you built. Approx how much did the engine tilt lift the back of the bike? I quite fancy having it done on mine. Is there any worries about oil pickup/ starvation/ checking? Cheers for the inspiration. Karl.
 


Back
Top Bottom