So I've measured the piston at 15.84mm I can just get a .06mm feeler gauge in to the bore with the piston. So the bore is close to 15.9mm I'd guess.
If you need an accurate size and can wait a week I’ll post you some bore gauges up but you’ll still need a 0-25mm outside mic to use with them.
If you need an accurate size and can wait a week I’ll post you some bore gauges up but you’ll still need a 0-25mm outside mic to use with them.
Really, REALLY sorry for the hijack ebbo but;
SIMON, pay yer subs, I can't PM you
Andres
That looks tidy
Hi fella, I've just resurrected our email conversation regarding the paint
......... I wasn't too surprised when the bleed nipple sheared off the brake caliper I'd used lots of heat but not enough it seems
Have you got this out yet? If not you need someone with a Mig welder. Place a steel washer over the nipple and slowly build up with weld until you have enough to get hold of with mole grips. It WILL come out and won't cause any damage if done carefully.
Took a car load of bits going to TripleS in Bingley for powder coat today
Wife seems to be tuning into the possible cost of all this, she has no idea
Yes, that really is a pair of airer frames
That looks a lovely job ebbo, the mudguard is super deep and shiny
Andres