John Roberts Well-known member UKGSer Subscriber Joined Mar 4, 2005 Messages 6,771 Reaction score 123 Location North Wales Jun 10, 2018 #1 Can anybody tell me on which end of which shaft the shielded bearing 6304RSR . C3 is supposed to go in my 1981 R100RS gearbox and also which side should the shield be on? Please?
Can anybody tell me on which end of which shaft the shielded bearing 6304RSR . C3 is supposed to go in my 1981 R100RS gearbox and also which side should the shield be on? Please?
KSAS Registered user Joined Sep 7, 2016 Messages 50 Reaction score 0 Location Nottingham Jun 10, 2018 #2 Lay shaft, with the seal facing away from the shaft. Like the picture attached. Sent from my HTC Desire 626 using Tapatalk
Lay shaft, with the seal facing away from the shaft. Like the picture attached. Sent from my HTC Desire 626 using Tapatalk
John Roberts Well-known member UKGSer Subscriber Joined Mar 4, 2005 Messages 6,771 Reaction score 123 Location North Wales Jun 10, 2018 #3 Good heavens! That was quick: four minutes! Thank you so much for that, I never expected an answer on a Sunday afternoon, I can carry on with the job now. Cheers
Good heavens! That was quick: four minutes! Thank you so much for that, I never expected an answer on a Sunday afternoon, I can carry on with the job now. Cheers
KSAS Registered user Joined Sep 7, 2016 Messages 50 Reaction score 0 Location Nottingham Jun 10, 2018 #4 John Roberts said: Good heavens! That was quick: four minutes! Thank you so much for that, I never expected an answer on a Sunday afternoon, I can carry on with the job now. Cheers Click to expand... Hope it all goes to plan Sent from my HTC Desire 626 using Tapatalk
John Roberts said: Good heavens! That was quick: four minutes! Thank you so much for that, I never expected an answer on a Sunday afternoon, I can carry on with the job now. Cheers Click to expand... Hope it all goes to plan Sent from my HTC Desire 626 using Tapatalk
Beemerboff Registered user Joined Mar 25, 2005 Messages 1,608 Reaction score 0 Location Adelaide,Australia Jun 11, 2018 #5 http://www.largiader.com/tech/airtrans/ Full details on bearings, end float has been revised to 5 to 15 thou. http://jeep.yager.net/docs/trans-to...f Sealed-Clean Bearings for Transmissions.pdf Some thinking on why there are seals on some gearbox bearings,further reading advised!
http://www.largiader.com/tech/airtrans/ Full details on bearings, end float has been revised to 5 to 15 thou. http://jeep.yager.net/docs/trans-to...f Sealed-Clean Bearings for Transmissions.pdf Some thinking on why there are seals on some gearbox bearings,further reading advised!