Can anybody tell me on which end of which shaft the shielded bearing 6304RSR . C3 is supposed to go in my 1981 R100RS gearbox and also which side should the shield be on? Please? 
Shielded gearbox bearing, '81 RS
- Thread starter John Roberts
- Start date
KSAS
Registered user
Lay shaft, with the seal facing away from the shaft. Like the picture attached.
Sent from my HTC Desire 626 using Tapatalk
Sent from my HTC Desire 626 using Tapatalk
Good heavens! That was quick: four minutes!
Thank you so much for that, I never expected an answer on a Sunday afternoon, I can carry on with the job now.
Cheers
Thank you so much for that, I never expected an answer on a Sunday afternoon, I can carry on with the job now.
Cheers
KSAS
Registered user
Hope it all goes to planGood heavens! That was quick: four minutes!
Thank you so much for that, I never expected an answer on a Sunday afternoon, I can carry on with the job now.
Cheers
Sent from my HTC Desire 626 using Tapatalk
Beemerboff
Registered user
http://www.largiader.com/tech/airtrans/
Full details on bearings, end float has been revised to 5 to 15 thou.
http://jeep.yager.net/docs/trans-to...f Sealed-Clean Bearings for Transmissions.pdf
Some thinking on why there are seals on some gearbox bearings,further reading advised!
Full details on bearings, end float has been revised to 5 to 15 thou.
http://jeep.yager.net/docs/trans-to...f Sealed-Clean Bearings for Transmissions.pdf
Some thinking on why there are seals on some gearbox bearings,further reading advised!
Similar threads
