Paralever gearchange shaft seal

Jon T

Active member
UKGSer Subscriber
Joined
Jan 13, 2005
Messages
232
Reaction score
2
Location
Sunny Warwickshire
Before I bugger something up, is the seal on the gear change shaft of my 1988 R100GS changed by pulling the lever off, firkling the old seal out, then pressing the new one in? Good old Haynes doesn’t seem to cover it.

Ta, Jon
 
Yes, a good clean with a cotton bud or similar is a good before putting the new seal in. Best done when you’re changing the oil.
 


Back
Top Bottom