2007 bike........ when out and about more often than not the ABS red light comes on and stays on. Switch off ignition and back on again, it re-sets and all is well until it comes on again. Riding at speed, high revs, bumpy roads all seem to provoke the fault, a gentle ride through town to/from work and its fine.
GS911 (Thanks Roger of this parish) tells me that its an "ABS pump fault, interrupted power supply to ABS pump, fault no longer present".
All of which points to a loose/corroded/cracked wire or connector.
SO tonight I've got to the ABS unit, which has 2 red positive wires, one brown earth wire and several other wires. The 2 positives and the earth wire all show up as good with a test probe inserted and no amount of pushing/pulling of the loom can provoke as much as a flicker in the probes LED.
Has anyone encountered this fault and if so whats the fix?
GS911 (Thanks Roger of this parish) tells me that its an "ABS pump fault, interrupted power supply to ABS pump, fault no longer present".
All of which points to a loose/corroded/cracked wire or connector.
SO tonight I've got to the ABS unit, which has 2 red positive wires, one brown earth wire and several other wires. The 2 positives and the earth wire all show up as good with a test probe inserted and no amount of pushing/pulling of the loom can provoke as much as a flicker in the probes LED.
Has anyone encountered this fault and if so whats the fix?