Guys,
After putting up with a minor leak from the LH Camchain Tensioner, I finally decided to replace the crush washer and tighten the bolt down properly.
Getting it out was a pig of a job. Getting it back in is not happening for me, the spring keeps the bolt under so much tension I can't get enough downward pressure in the confined space available to get the bolt started on the tread. Any ideas?
Cheers
Bill
After putting up with a minor leak from the LH Camchain Tensioner, I finally decided to replace the crush washer and tighten the bolt down properly.
Getting it out was a pig of a job. Getting it back in is not happening for me, the spring keeps the bolt under so much tension I can't get enough downward pressure in the confined space available to get the bolt started on the tread. Any ideas?
Cheers
Bill