Like so many others, my hammy fists have broken one of my stubs (plastic). Lots of people have asked..... Tom Parker Pneumatics supply these to the Triumph factory: BRASS COUPLING INSERTS - IN-LINE - VALVED - HOSE BARB 8mm
This is the male section that breaks. Part number: cLCD220-05V TUBING SIZE: 5/16" ID, METRIC EQ.: 7.9 mm ID
At the time of writing they are £18.34
This link should take you to the correct page on their catalogue, where you can find Female, Male and Elbow versions in either plastic (BUT MAKE SURE YOU GET PART NUMBER WITH A 'V' for VITON) or chromed brass.
https://www.tom-parker.co.uk/products/cpc-plastic-and-brass-couplings/2/fuel-line-couplings/61/
I hope that helps a few folks out.
This is the male section that breaks. Part number: cLCD220-05V TUBING SIZE: 5/16" ID, METRIC EQ.: 7.9 mm ID
At the time of writing they are £18.34
This link should take you to the correct page on their catalogue, where you can find Female, Male and Elbow versions in either plastic (BUT MAKE SURE YOU GET PART NUMBER WITH A 'V' for VITON) or chromed brass.
https://www.tom-parker.co.uk/products/cpc-plastic-and-brass-couplings/2/fuel-line-couplings/61/
I hope that helps a few folks out.