This Winter's G650X Project
- Thread starter nicholsonj2252
- Start date
No changes to bike required - it is a BMW approved part and the BMS Controller adjusts accordingly
Don't those Akrapovic Titanium full systems look the biz
Micky - you just need a pair of black plastic frame plugs to fill that big hole in your frame now to finish it off ;-)
Managed to get the engine all done today - new clutch cover (later type with steel insert) , new water pump and seals , new water pump cover , Stainless manifold studs and copper nuts . Checked all of the valve clearances , all were well within tolerance and put in a new oil filter . All engine casing bolts replaced with A2 stainless and coolant pipes re-fitted with SS Jubilee clips
Looking good, excellent work.
Where did you get the copper flashed flange nuts from and can you remember what size M6 studs you got?
https://www.ebay.co.uk/itm/BMW-5-Se...-HEX-FLANGE-/401349213620?hash=item5d7246fdb4
https://www.ebay.co.uk/itm/M8-x-40-...antity-/301358346021?var=&hash=item462a5b6f25
Nice job
Split the front brake caliper - the XMoto has a 4 pot caliper (rather than the two pot on the XChallenge and XMoto) and fitted all new seals , O rings and new OEM pads . All re-assembled with SS bolts
A future Classic for sure 
Wow! (oh, post too short apparantly) so, Wow Wow Wow! 
Not much time this morning as I'm going out , so just re-built the rear brake caliper with new seals and pads and removed and re-fitted the new lower head bearing to the steering stem
First of the parts back from the Powder Coaters ....
Get the tyres fitted tomorrow then collect the rest of the parts Thursday
A weekend of assembley lies ahead
Get the tyres fitted tomorrow then collect the rest of the parts Thursday
A weekend of assembley lies ahead
That's one heck of a big disk! Is it standard?
Yes standard on the XMoto - 4 Pot Brembo calipers and a 320mm Disc ;-)
Wheels now fitted with a nice pair of Pirelli Angel ST tyres
Early Xmas present....
Similar threads
