2019 250excf.
I recently fitted genuine wraparound handguards to my bike to replace the little ones that it came with.
In the bag of bits supplied there was a couple of pivot pins/bolts for the clutch and brake levers. These were duly fitted , the nut screws on far enough to engage the nyloc insert and it all works just fine.....but there's a gap under the head of the pivot pin/bolt.
I've got no bits left over but it looks like there should be a spacer or washer under the head.
Can anyone confirm if there is something missing please?
Not unduly worried but it's a fairly crucial pivot pin and it would be nice if it stayed in its place...
It's the bolt head visible to the right of the plastic adjuster knob-- gap visible between the head and the casting.
Thanks
I recently fitted genuine wraparound handguards to my bike to replace the little ones that it came with.
In the bag of bits supplied there was a couple of pivot pins/bolts for the clutch and brake levers. These were duly fitted , the nut screws on far enough to engage the nyloc insert and it all works just fine.....but there's a gap under the head of the pivot pin/bolt.
I've got no bits left over but it looks like there should be a spacer or washer under the head.
Can anyone confirm if there is something missing please?
Not unduly worried but it's a fairly crucial pivot pin and it would be nice if it stayed in its place...
It's the bolt head visible to the right of the plastic adjuster knob-- gap visible between the head and the casting.
Thanks