250excf handguard fitment question.

Status
Not open for further replies.

steadysteve

Well-known member
UKGSer Subscriber
Joined
Feb 26, 2012
Messages
2,506
Reaction score
46
Location
Lincolnshire
2019 250excf.
I recently fitted genuine wraparound handguards to my bike to replace the little ones that it came with.
In the bag of bits supplied there was a couple of pivot pins/bolts for the clutch and brake levers. These were duly fitted , the nut screws on far enough to engage the nyloc insert and it all works just fine.....but there's a gap under the head of the pivot pin/bolt.
I've got no bits left over:D but it looks like there should be a spacer or washer under the head.
Can anyone confirm if there is something missing please?
Not unduly worried but it's a fairly crucial pivot pin and it would be nice if it stayed in its place...:thumb2
It's the bolt head visible to the right of the plastic adjuster knob-- gap visible between the head and the casting.
Thanks
 

Attachments

  • IMG_20200605_135752.jpg
    IMG_20200605_135752.jpg
    219.6 KB · Views: 100
Try the UK KTM Forum, lots more owners of these hang around there.
 
Status
Not open for further replies.


Back
Top Bottom