Harpenden16
Registered user
For the love of god i at take off the pushrods from both the intake valve and exhaust valve. I marked up both rods and put them in separate bags. On reassemble the bloody intake push rod will not sit correctly into the tube seal. its not flush at all and sticks out by 30mm.
The push rods for the exhaust valve sits absolutely fine, wtf is going on ???
The original seals seem ok with no leaks. Why won't the intake push rod fit correctly ffs..........................................
Any advice would be well appreciated. kind regards
The push rods for the exhaust valve sits absolutely fine, wtf is going on ???
The original seals seem ok with no leaks. Why won't the intake push rod fit correctly ffs..........................................
Any advice would be well appreciated. kind regards