So there I am all pleased at getting a new EnduroGuard jacket for reasonable money but I can't get the yellow armour to fit in the jacket correctly.
Especially the elbow armour doesn't even come close to being enveloped in the material lining. The shoulder armour is just about acceptable but not completely covered with lining material.
Am I missing something? The shoulder armour is labeled right and left shoulder large (jacket is 54) and has an arrow pointing to "NECK". Likewise the elbow armour is handed and has "TOP" printed on it.
Something is wrong. When the jacket arrived the two shoulder armour were inserted in the elbows and the elbow armour was loose in the box. Maybe this was a clue?
Any suggestions appreciated. If you have same size jacket and the armour is out maybe you could look at the size. Very frustrating.
Thanks.
Especially the elbow armour doesn't even come close to being enveloped in the material lining. The shoulder armour is just about acceptable but not completely covered with lining material.
Am I missing something? The shoulder armour is labeled right and left shoulder large (jacket is 54) and has an arrow pointing to "NECK". Likewise the elbow armour is handed and has "TOP" printed on it.
Something is wrong. When the jacket arrived the two shoulder armour were inserted in the elbows and the elbow armour was loose in the box. Maybe this was a clue?
Any suggestions appreciated. If you have same size jacket and the armour is out maybe you could look at the size. Very frustrating.
Thanks.