Hi there,
I know this thread is quite old now but it absolutely applies to what I am trying to achieve. I bought the Denali D2 kit because the fitting diagram looked astonishingly straightforward. It came with a full wiring loom which has a + and - straight to the battery connection as well as an ignition trigger wire and a high beam trigger wire. I too have a PDM 60 and my plan was to take the ignition trigger from the PDM 60 and then splice into the main beam trigger wire to achieve the high beam functionality. It looks like the Denali wiring loom has a relay built in and a separate switch which allows you to turn the lights on and off. Am I right in thinking that the instructions you give here are if the Denali loom is not used? I am not sure why you need a separate relay for the high beam. There is no mention of this in the fitting instructions? Just - as a side issue - Exactly where did you pick up the high beam trigger wire and I would be very grateful if you could let me know the colour of it. Many thanks for any help you can provide.