I created this thread. This all started in a thread about routing problems, stemming from routes created in MotoGoLoco / Tyre, not reproducing themselves properly in a Nav VI device. Richard...
Mapsource works with all new devices, you just have to set them into mass storage mode! If the OP has Mapsource I can't see the point of using a third party system, which as has been pointed out, uses different maps. Why not just plan in Mapsource using the maps that will be on the device? Have I missed something, does this third party system do something special?
John
...did you try basecamp, just wondering as mapsource is said to be incompatible with newer devices.....
Mapsource works with all new devices, you just have to set them into mass storage mode! If the OP has Mapsource I can't see the point of using a third party system, which as has been pointed out, uses different maps. Why not just plan in Mapsource using the maps that will be on the device? Have I missed something, does this third party system do something special?
John