I am in the process of planning my 2018 Picos/Pyrenees trip using Tyre To Travel software which came free with my recently purchased TomTom 450, but the issue I have is when planning my routes of numerous Pyrenean Cols I can enter a waypoint towards the summit but when I attempt to enter my next waypoint at the base of the climb it suddenly routes me around the Col instead of up and over.
I’ve tried on numerous occasions but always the same result, for some reason it won’t allow me to route up and over and down the other side.
All my other routes which I’ve planned my trip have worked fine, it’s just the climbs.
I cannot fathom out why it does this apart from the fact that at present the route may be impassable due to winter snow...!
While I have to admit that this is my first attempt at satnav route planning so my experience with such software is very limited.
If anyone could perhaps shed some light onto my problem it would be greatly appreciated.
Thanks in anticipation.
I’ve tried on numerous occasions but always the same result, for some reason it won’t allow me to route up and over and down the other side.
All my other routes which I’ve planned my trip have worked fine, it’s just the climbs.
I cannot fathom out why it does this apart from the fact that at present the route may be impassable due to winter snow...!
While I have to admit that this is my first attempt at satnav route planning so my experience with such software is very limited.
If anyone could perhaps shed some light onto my problem it would be greatly appreciated.
Thanks in anticipation.