I have basecamp on PC but cannot use it to create routes but thought after reading the forums that most routes sent to you or downloaded from say 'ride "magazine should ideally be loaded onto Sat Nav via BC
So thought I would give it a try
For recent trip I had a GPx route in the Morvan sent to me by another member of this forum.
I transferred the file into basecamp
Basecamp showed both a Route Gpx and a Track under it in the list
When opened on PC the Route showed the route and all waypoint flags
I transfered the Route ( not the track) to my 390 Zumo. All looked ok and opening it all the waypoints were listed
However once in the Morvan the San nav would only take me to the next waypoint on the route . From there I had to start up the route again and highlight next place on route and so on and so forth
What did I do wrong?
So thought I would give it a try
For recent trip I had a GPx route in the Morvan sent to me by another member of this forum.
I transferred the file into basecamp
Basecamp showed both a Route Gpx and a Track under it in the list
When opened on PC the Route showed the route and all waypoint flags
I transfered the Route ( not the track) to my 390 Zumo. All looked ok and opening it all the waypoints were listed
However once in the Morvan the San nav would only take me to the next waypoint on the route . From there I had to start up the route again and highlight next place on route and so on and so forth
What did I do wrong?