Hex EZcan and USB

[Bigcats]

I'm looking at purchasing one and one of the ideas I have it to put a USB socket in the top box via an SAE connector for ease of connecting/disconnecting.
However I want to make sure the Ezcan will power the USB socket OFF after I switch the bike off (so even if I leave something charging in the top box it will just stop)
I have a 2019 GSA so I will be buying a gen 2

 

[Bigcats]

Its ok I found this so basically yes

12v into top box

Ok so I’ve got a usb point wired directly to the battery for charging stuff up on trips etc. My problems are that obviously if you park up you have to remove whatever you are charging and it’s not mega practical when riding if I want to keep something charged. So my thoughts are a bulkhead...

www.ukgser.com

 

[Anthony Byrne]

Yes power will stop once the bike is off

 

[HEX Support]

Hi Bigcats

Yes, the accessory output can be configured to have a delay, should you require it. So when ignition turns off, you can configure this in the ezCAN software to turn off between 0 and 60 seconds after ignition is detected as off.

Kind regards and safe travels

 

[Bigcats]

Hi Bigcats

Yes, the accessory output can be configured to have a delay, should you require it. So when ignition turns off, you can configure this in the ezCAN software to turn off between 0 and 60 seconds after ignition is detected as off.

Kind regards and safe travels

Many thanks for the reply and its on order from Motorworks so looking forward to getting it connected