My project needs measurements

[Bendy toy]

Well done looks good.

Google search with "UKGSer" in front of your search text is a better way to find information on UKGSer. You can remove the flap valve and actuator with no dashboard warnings. You will need a short pipe and clamps to fill the gap.

The earlier model exhaust systems (pre 2010) will drop straight onto the twin cam. Exhaust ports and hanger points are all the same.

 

[olsin77]

Thank you Bendy Boy.
As i had one akrapovic for a pre dohc hanging around my garage.
I will check that now.
Thanks again

Sent from my HTC_M910x using Tapatalk

 

[Bendy toy]

The muffler can for an older bike might not fit a twin cam header. An older model header with older muffler can should fit.

 

[olsin77]

I will try both ways and report here. Thanks for the heads up.

Sent from my HTC_M910x

 

[olsin77]

Quick update to this. After a lot of thoughts i will leave the factory one on there. But will sell the gsa as it is and i am a bit sad for it to let it go. But garage is full and need some cash now

Sent from my HTC_M910x