R1250GS and R1250GSA Panel strip down

[littleade]

A couple of useful videos from abikething https://www.youtube.com/channel/UC6qOxskyJsJNVgMbrc2vdzQ Showing how to remove your panels if you want to fit electrical accessories like Denali lights or a soundbomb etc and which screws go where so you don't put the wrong one back in the wrong place risking panel damage

https://youtu.be/242hxrDX5F8

https://youtu.be/Hf0G3_MCDas

 

[Edventure]

Very useful. Perhaps make this sticky?

 

[bosnjo]

This will help me a lot. My new bike still hasn't arrived and I have a lot of accessories to install.
Thanks

 

[Zx9man]

Steve is a good man just wait till he starts changing clutches

 

[littleade]

This will help me a lot. My new bike still hasn't arrived and I have a lot of accessories to install.
Thanks

They're 2 of the most useful videos I've seen so please give him a like and comment on them to help his channel (I have no vested interest here just think we should show our support even if we don't buy anything off him)

When I took the panels off my 1st GS I got a card board box and drew the shapes of the pannels on it and punched holes through to hold the screws so I knew where they went. Now I'm a bit more used to doing it I put the screws for each panel in a small container (I use the plastic pots that come with liquid washing detergent) but these are still brilliant reference videos no matter how often you've done it.

 

[Winjar]

Will be good help to change front suspension.

 

[T Dog]

I did my strip down with no guide at all. Just have the 2 bolts left over...