Zumo 550 wont switch on or charge

how much for a service!

Active member
UKGSer Subscriber
Joined
Jan 17, 2006
Messages
390
Reaction score
0
Location
Various
Hi bit of advice please
Bought this unit and bike mount off a fellow gser a little while ago
fitted it, all was fine
Then on a trip through france it started coming up with a message
something like "this accessory not supported" so obviously ignored it
but then noticed it didn't seem to be charging and eventually it just ran out
of charge and died.
tried charging it with the mains adaptor no luck, took the battery out put it back
in no difference, up until this problem the battery had been holding charge well.
Could it be simply a battery failure or something more terminal?
Cheers
 
Its quite common for the mounts pins to get corroded especially if power is always on. You may be lucky and a good clean up and spray with something like ACF50 but if not, you're looking at a new mount. I had the same issue as you and that was the problem with mine.
 
You could try a soft reset. Hold the +button top left hand and the power button until it boots up.
 
Yep very technical.. I can fix most things but I'm afraid there is nothing deader than a dead garmin.....
 


Back
Top Bottom