I assuming you’re being humorous..?
Sadly not……
I assuming you’re being humorous..?
I assuming you’re being humorous..?
Put the new pushrod in but having trouble getting the circlip back in. Can't seem to get Bearing in anymore.
Now sorted. Remembered that Si said there was a bit of resistance getting the bearing in.
And shite circlip pliers didn't help. Oil wants topping up a small amount.
The bearing is slightly sprung and wants to slowly push itself out. Push it in with your thumb, at the same time getting the circlip/snap ring wedged in it's position.
I'm like a master mechanic now.
What’s the “thing” at 13:00 that looks like a rucked seal?
More like a baby slug.
Look at your picture, centre on the bearing and look up at 1300 towards the outer flange with the printed numbers, a small grey protruding piece … looks like a trapped seal… dies not look right to me..
That Pal ? In middle of red circle.
Ooh. That’s coming out again very soon!
Not its not, it's a nub aligned with a "slot" (correctly aligned in pic) They have to be aligned correctly otherwise the bearing cannot be pushed in enough to allow the circlip/snap ring to be put back in.
Not its not, it's a nub aligned with a "slot" (correctly aligned in pic) They have to be aligned correctly otherwise the bearing cannot be pushed in enough to allow the circlip/snap ring to be put back in.
Spoilsport….
Sorry...should have dragged that one out a little longer
How's it going with the RKS gearbox??
Done and dusted…..amongst other things…..on the Dyno today….