Is there an easy way to skip a waypoint on the Zumo 350?
When using Mapsource/Basecamp to create a route I usually use a start/end point and then shape the route by dragging the work to where I want to go. The device recalculates quite happily if you go off the route at times.
On the recent trip I did a couple of routes on the Zumo 390 itself, using start/end points and then intermediary waypoints. Sometimes these waypoints were not exactly where we rode and I wanted to skip that waypoint and go on to the next one.
On some satnavs you can simply tell the device to skip the waypoint and it re-plots your route to the next one. The Zumo 390 does not seem to have this option. All I could work out to do is to open the route and manually start it again from the next waypoint. This is a PITA as it is not a simple one press option you can do whilst riding.
When using Mapsource/Basecamp to create a route I usually use a start/end point and then shape the route by dragging the work to where I want to go. The device recalculates quite happily if you go off the route at times.
On the recent trip I did a couple of routes on the Zumo 390 itself, using start/end points and then intermediary waypoints. Sometimes these waypoints were not exactly where we rode and I wanted to skip that waypoint and go on to the next one.
On some satnavs you can simply tell the device to skip the waypoint and it re-plots your route to the next one. The Zumo 390 does not seem to have this option. All I could work out to do is to open the route and manually start it again from the next waypoint. This is a PITA as it is not a simple one press option you can do whilst riding.